1973 Porsche 914-6 2.7L Conversion

1973 Porsche 914 Description:

Please check my feedback - I'm a reputable seller on eBay for over 17 years.
This is an original California car, records going back to 1986.
Conversion with mostly factory parts:
911SC front end with Bilstein inserts
914-6 stub axles
914-6 oil tank
914-6 heat exchangers (restored ~2 years ago)
Engine:
Otto's rebuilt 1977 911S 2.7L engine (engine #6272366, engine type 911/85) with modified cams, machined case, etc. Receipts over $18,000+ back in the late 90s. Compression 185-195 across all 6, approximately 10,000 miles on rebuilt engine
Added Carrera hydraulic tensionsers ~2 years ago
40IDA3C Weber Carbs
Crane ignition
New Bosch alternator ~3 years ago
New 914-6 throttle cable
New fuel sender
Cosmetic:
Non-stock metallic blue over original Olympic blue, from the late 90s.
Repro polished stainless steel early-style bumpers, undrilled front bumper, new factory chromed fog grills
New bumper tops
GT style engine deck lid
Center reflector insert
Rebuilt fog lamps with new OEM yellow Hella covers
Fresh wiper arms and nuts
Hell hole is solid, as is the rest of the car
Interior:
Remanufactured dash top with ashtray delete
German loop carpet in cinnamon
Brown vinyl interior 9/10
Restored gauges + custom 4 gauge (oil, temp, volts, fuel)
Momo prototipo steering wheel + offset spacer for more leg room
New Blaupunkt radio with bluetooth
6" round Blaupunkt speaker pods
8" fiberglass subwoofer in passenger footrest location
New aluminum door sills
New carpets and CoCo mats
Lots of fresh gaskets and other bits
Others:
Brakes - replated & rebuilt rear calipers, rebuilt front calipers and new MC
Bilstein HD shocks + Ground Control coilovers
15x7" replica 914-6 GT wheels from Group 4 Wheels (http://group4wheels.com/wheels_pag1570.php) under slightly rolled fenders, 205-55 Toyo tires
Optima Redtop AGM battery (new)
New shift bushings
Remaining minor issues:
Oil leaks - no more than usual for 2.7L
Fresh air blower doesn't work - don't really miss it either
Rust bubbles from bad windshield install (see pictures) - surface rust only, metal is solid
Rust bubble on right rear fender lip (see picture)
If you look closely, minor body work needed on inside left front wheel well to make perfect (see picture). Body is perfectly straight with paperwork from Custom Alignment (suspension specialists) in Mountain View, CA.
Jackpoints should be ground off and replaced
Tach bounces sometimes when you have the turn signal on?
No front spare tire (picture of tire in front trunk outdated)
1st gear synchro will need replacing in a year or two.
I'm selling because I need a daily commuter but Bay Area traffic is horrendous and not fun to drive a fast car slow all the time. I also have a new baby and need something with a back seat. I bought in September 2017 and have put about $4,000 in sorting out little issues like full tune up, sticky throttle cable, frozen fuel sender, worn out shift bushings, etc. It now runs as well as you can expect with technology current 45 years ago. Starts no problem, revs happily past redline in a heartbeat, suspension is tight but not punishing, will inspire terror and a stupid smile on your face. Will also confuse all the fast cars you leave in your dust because "it's only a 914?!".
Any questions about the car, please feel free to contact my Porsche mechanic, Bill Eason, of Eason Auto Works: http://www.easonauto.com/ or (510) 420-1262.
Happy to arrange pickup with shipping company of your choice. Good luck.