1968 Plymouth Barracuda Notchback- great condition!

1968 Plymouth Barracuda Description:

For sale is a 1968 Plymouth Barracuda Notchback. Perfectly straight body with no rust. Engine is a 5.9L, 360 Dodge Magnum with approximately 60,000 undocumented miles with Edelbrock 4 barrel carb. Transmission is the original 727 TorqueFlite 3-speed automatic. Manual steering and brakes. Dual Magnaflow exhausts sound great. The car runs perfectly, starts right up, drives straight and fast. It's been garage kept in heated garage, never driven in the snow. Extremely well cared for as the pictures clearly show. Everything works on this car, I even have the original build sheet. This car turns heads and deservedly so. Upgrades are too numerous to list, but here's a short list of the most recent ones:
New electronic ignition
Newer fuel tank, fuel lines
New oil pan/gasket
Bluetooth stereo with speakers in dash and rear deck
New dash dimmer/light switch
with LED lights in dash.
New quiet fuel sending unit and relay
New choke and coil
Most weatherstripping replaced throughout the entire vehicle including front and rear glass, doors, trunk.
Newer dash pad, Refinished gauges, needles and circuit boards
Newer battery, cables, voltage regulator
Front end parts replaced- lower ball joints, inner and outer tie rods, idler arm, pitman arm, rubber on control arms, bushings on radius and control arms, bump stops
New Rear Shocks and Alignment
Here is a link to a video of the car:https://www.dropbox.com/s/2pgp0j94krazey2/68%20CUDA.mp4?dl=0
I'm in no particular hurry to sell, just looking for a good owner to enjoy this car. No trades or low ball offers please, serious inquiries only. I'm selling this car locally so I have the right to end the auction at any time. Thank you.

On Oct-19-18 at 10:39:40 PDT, seller added the following information:

This car drives great, runs beautifully. I have fine tuned many details since I have owned it- lot's of nice upgrades and handled it with much TLC. Everything works except bench set is stuck into it's rear position. I'm sure it can be fixed by removing the seat and working on the release mechanism.