1930 Ford Tudor Sedan

1930 Ford Model A Description:

1930 Ford Tudor Sedan that needs to be enjoyed. This was a ground up build 10-15 years ago with no expense spared by an individual who likes the building process but is too busy to enjoy them when completed. The car has a TCI Chassis with an dropped I-Beam front end and a Ford rear end. The car has a small block Chevrolet 350 engine dressed up with Mallory Ignition, Offenhauser tunnel ram intake with a single four barrel Edelbrock carb, cal custom valve covers and a TH350 Transmission. The top has been chopped and appears to be very well done. This car has had very few (guessing less than 2K) miles since it was put together and seem to go down the road very well. If this car was built today would cost well over 40K to build and could take years. This one can be bought for a fraction of the price and you could enjoy it right a way.