1938 Chevy Coupe Gasser

1938 Chevrolet Other Description:

1938 Chevy Gasser Coupe 383 stroker Scat forged rotating assembl, 10-1 compression pump gas friendl, Brodix head, Edelbrock tunnel ra, two 660 Holleys, 630 solid roller ca, around 600 hp . TH 350 with manual reverse valve bod, 4500 stall and trans brak, 4” aluminum drive shaft with billet yoke, 1963 Pontiac rear end with 3 rib case and Fab Craft posi unit good for 1000 h, 456 gear Strange axles. 10 gallon fuel cell and a Holley 150 fuel pump . Inside of the car steering wheel is a Superior 500 from 196, shifter is a B&M 60 serie, from the early 1960, tach is a 1968 Sun Tac, other gauges are 1964 Stewart Warner . Bench seat 4 point roll bar . Rear wheels are American Racing Wheels with new M&H Race Master tire, front wheels are 3 1/2 “ Cagar wheels with Firestone 5-60s . There are a lot of new parts on this car ! This car was finished this year and has under 500 miles on it . I do have the hood for the car if you want to put it on . Very well built ready for the track or the show which is what I have been doing with it !! It run 10.60s in the quarter and 6.80s in the 1/8th . I built this car keeping very close to the way they were built in the 60s. This is a true nostalgic Gasser ! There’s a lot I haven’t written down about the ca, so call and ask any questions you may have . I might trade for a Second or third generation Corvette . Curt @ 310-980-6476 thanks for checking it out !!